Recent Posts

View All
PICOTEST J2101A Injection Transformer 10Hz~45MHz
  • PICOTEST J2101A Injection Transformer 10Hz~45MHz
  • PICOTEST J2101A Injection Transformer 10Hz~45MHz

PICOTEST J2101A Injection Transformer 10Hz~45MHz

PICOTEST
  • 10Hz supports off-line power supplies
  • 45MHz high enough for even state of the art regulators
  • 23 Octave range
  • Low distortion for superior precision
  • 5 Ohm termination for minimum impact to loop
  • Includes attenuation to assure small signal measurement cilloscopes and and Spectrum Analyzers
Call for availability & lead time
Description

The injection transformer is presently the prevalent method for connecting the network analyzer to the circuit being tested, and is primarily used for control loop stability measurements. The goal of the transformer is to inject a signal into the control loop being measured, without impacting the performance of the loop. In order to accomplish this to a reasonable degree, The transformer is isolated and therefore is capable of floating on a high voltage, such as a Power Factor Corrector (PFC), which is often close to 400VDC. Measuring voltages that exceed the voltage rating of the Bode-100 inputs require attenuation probes.

The usable bandwidth of an injection transformer is generally significantly greater than the 3dB frequency limits. This is because the transformer itself is outside of the measurement, leading many to incorrectly believe that the transformer is a non-critical element.

The bandwidth of the transformer is strongly related to the terminating impedance. The Bode-100, and most network analyzers, provide a 50 Ohm oscillator source impedance. Assuming this impedance the optimal termination resistor is 5 Ohms. This significantly attenuates the injection signal, which is generally beneficial, as a common error in Bode measurements is using a signal which is too large, and therefore not a small signal measurement. An added benefit of this low value is that it can generally be left in circuit at all times, simplifying the connection to the network analyzer without appreciably impacting the output voltage of the circuit being tested.

Product Details
5 other products in the same category:

Brand: PICOTEST

PICOTEST J2112A High Current Injector DC~40MHz

• Fast Transient Load Stepping up to 1Amp • 20nSec typ rise and fall time • DC-40MHz usable range (interconnection dependent) • Measures non-invasive phase margin, output impedance, reverse transfer, crosstalk, input filter stability • Works with positive voltage sources • Built in offset for use with Network Analyzer • Precision current monitor with 50...

Call for availability & lead time

Brand: PICOTEST

PICOTEST J2110A Solid State Injector DC~45MHz

• DC-45MHz; supports thermal and mechanical controls and highest performance regulators and amplifiers • Low distortion for superior precision • 25 Ohm insertion resistance • 50 Ohm oscillator input • < 3uA typical bias current • >2 MΩ typical Input Resistance • High PSRR low noise regulator with universal input

Call for availability & lead time

Brand: PICOTEST

PICOTEST J2111A Current Injector DC~40MHz

The versatile current source you can’t be without; enables high fidelity load step, impedance, and stability measurements • Enables non-invasive phase margin testing • High speed load stepping current source – 20nSec edges • DC-40MHz usable range • Bi-Lateral operation works with positive or negative source • Built in current offset for use with a network...

Call for availability & lead time